Current location - Health Preservation Learning Network - Health preserving recipes - Matters needing attention in biochemical incubator
Matters needing attention in biochemical incubator
1. The biochemical incubator should be installed in a place where the temperature and humidity change little as far as possible, with a three-pin plug? The socket should be properly grounded.

2. Before starting the biochemical incubator, you should be fully familiar with and understand the instructions of supporting instruments and meters, and master the correct use method.

3. It is forbidden to contain volatile chemical solvents? Put explosive gas and combustible gas in the box, and don't use flammable spray near the incubator? To avoid spark ignition.

4. Be sure to check whether the gas path leaks.

5. The biochemical incubator has the power-off protection function, so it takes about one and a half minutes for the compressor to start again after stopping, so as to better protect the compressor.

6. The distance between the condenser and the wall of the biochemical incubator should be greater than 100mm, there should be a gap of 50mm on the side of the incubator, and there should be at least 300mm space at the top of the incubator to ensure good heat dissipation.

7, biochemical incubator in handling, maintenance, maintenance should avoid collision and shaking vibration, the maximum inclination should be less than 45 degrees.

8. When you stop using for a long time, please turn off the main power supply and the power switch on the back of the equipment. ? At the same time, the biochemical incubator should avoid frequently opening the door to keep the temperature stable and prevent dust and dirt from entering the studio.

9, inside and outside the box should be kept clean every day, and should be cleaned after each use. If you don't use it for a long time, you should always wipe the tank wall and equipment surface to keep it clean and increase the transparency of the glass. Do not wipe the external surface with acid, alkali or other corrosive solutions.

10. Turn off the power switch after the culture. Please don't open the door unless you take out the experimental samples at once.

1 1. The biochemical incubator should not be used in abnormal environments such as high voltage, high current and strong magnetic field, and should be strictly implemented in accordance with electrical safety operation procedures.