1. If the cyclone floor drain is installed near the wall, just cut the bathroom floor tiles outside the wall along straight lines on both sides to make the floor tiles form a diagonal line. When laying the cyclone floor drain, be sure to make the floor tile tilt to the corner as far as possible, so that the cyclone floor drain can be located in the subsidence area, which is more convenient for drainage.

2. If the cyclone floor drain is installed in the center, then the four corners of the cyclone floor drain should be aligned with the reticle of the bathroom floor tile, and then the floor tile should be cut in all directions, which can not only ensure the integrity of the floor tile, but also make the slope of the floor tile more natural and difficult to accumulate water.

3. When installing the floor drain, be sure to block the drain with a rag or plastic bag in advance, so as to avoid mortar and foreign matter entering the drain and causing pipeline blockage. When installing the floor drain core, you can take off the blocked rag or plastic bag.

When installing the floor drain, make sure that the height of the floor drain installation position is lower than the height of the surrounding ground, so that water will flow to the floor drain from a height.