A beautiful and well-fitted version of pet clothes will not only make your baby feel comfortable, but also attract the envy of others, make you feel that you are the owner's honor and satisfy your baby's little vanity!
There are many dog clothes on the internet now, but the size and quality are not easy to master. In this case, it is better to make a dress for the dog with your old clothes! Simple and loving.
First, measure the dog's clothes.
We can refer to the picture below and measure the dog with a soft tape measure. The clothes made by this way are very comfortable for the dog to wear.
take one's measurement
Second, cut it into the following shape.
We cut a piece of cloth into the following shape, which is the prototype of dog clothes. We have measured the length of neck position and leg position. If the back is long, we can make it different lengths according to our needs.
Cut it like this
Third, suture
We just need to sew the blue part of the picture below and nail the small buttons on the pink part, and a simple dress can be finished!
suture
Fourth, show
It looks like this. You can also decorate some lace, hats and the like according to your hobbies.
Suture effect
I have done it myself, hehe, I haven't seen the tutorial.
The most important thing to make dog clothes is to measure the dog's "three measurements", that is, neck circumference, body length and chest circumference.
There are two ways:
1, go and buy a ready-made dress suitable for dogs, and measure the neck circumference, body length and chest circumference according to the size of the dress. Find a piece of cloth with the right color, draw it with chalk, and then you can start cutting. If it's the first time to do it, I suggest you try to cut it with the newspaper first, then cut it against the cloth with the newspaper after cutting, and then you can sew it up.
2. If you don't buy ready-made clothes, skip to the second half of the first step, measure the dog's measurements, and try to cut them with newspaper ... It takes many attempts to ensure that the dog's clothes fit.
The first time I did it, I used the second method. It took me several times to get it right.
Thank you, I only know.
Measure enough cloth according to the dog in advance, roll it up as follows, cut a semicircle at the position of the forelimb, and it will be a complete circle after opening, just enough for the dog's two front feet to protrude from here:
Open it and sew it with needle and thread step by step in the order shown in the picture. Pay attention to the place where the front and rear pieces are connected, because they often pull with the dog's movements, so we might as well sew more lines to ensure that the finished dog clothes are durable enough.
Because there is a tail on pp, the front piece of clothes should put some material slightly forward than the back piece, so that the tail will not be covered by clothes. Use scissors to subtract a big V shape from the front piece, which is beautiful and simple.
The rest is decoration and packaging, just use chiffon or ribbon.
Add two small buttons on the back to make the puppy's clothes cuter.
Simple puppy clothes making process, detailed! ! !
Tools: unwanted cloth, scissors, ruler, sewing machine.
1, first measure the size of the puppy's body with a ruler, and then measure the size of the cloth.
2. Then start making, sew the patterns in the following pictures in turn, pay attention to the range of action, and try to be strong.
3. Then cut a hole in the tail of the clothes to expose the puppy's tail.
Next, sew them along the seam with sewing machine.
Finally, you can sew a bow, and then you can do it.
I'm good at this. The easiest way for me to make clothes for our dog every day is to take a piece of cloth, preferably a little bigger than the dog's waist. And then sewn to form the barreled cloth of the dog waistline. Determine which side is behind the stomach and cut off the clothes where the dog urinates. Divide the belly face in half, cut off the upper half between the two sides, and cut off the mouths of the dog's two front legs. The last step is to remove the neck part and you're done ~ I hope to adopt it, hee hee.
The whole process of making dog clothes (Figure)
The whole process of making dog clothes:
1, material: cotton cloth (50× 50cm), all kinds of fragmentary lace.
2, start making the back: first draw half of the back on the paper and cut it open.
3. Fold the cloth inside. Yes, remember that the cloth is slightly larger than the pattern.
4. Cut the back piece of the sample, preferably slightly larger than the sample. You can't change it when it's small.
5. Start making the front film, and also cut out the pattern on the paper first.
6. Check the back film and sew it.
7. Back decoration: Sew the edges first.
8. Decoration.
9. Finally, sew sleeves on the clothes and lace on the collar.
Measure the neck circumference: the neck circumference refers to the circumference of the dog's neck, in other words, the circumference of the place where the collar is usually worn. When making clothes, the neckline should not be too wide or too narrow, usually 1 cm wide.
Measurement of bust: bust refers to the circumference of the widest part of the root of its front leg. Usually, this is also the fattest part of a pet. Because this place is thick and fleshy, it is difficult to measure it accurately. Generally, at least 2 ~ 3 cm should be put.
Measuring length: please note that it is not the whole body length to be measured, but the length from the back of its neck to the tail root. When measuring the body length, make sure that the dog stands up straight and completely spread out, and don't lie down or lie down, otherwise the measurement will be inaccurate.
In addition, if you want to make more exquisite pet clothing, you'd better measure its leg length, the distance between its two front legs and the length of its lower body. Some special pets need to be measured in specific parts. For example, some dogs have beer bellies due to overnutrition, so the size of the belly circle should be released during the process of making clothes for them, which can greatly improve the accuracy of measurement.
How to make dog clothes with four legs and illustrations?
1) according to the actual size of the dog, cut one piece of clothing main fabric and two pieces of clothing sleeve fabric.
2) After the clothes sleeves are folded in half, they are sewn and fixed, and the two sleeves are treated the same.
3) Put two sleeves on the left and right cuffs respectively, and sew the sleeves and cuffs together.
4) Fold the upper and lower edges of the piping cloth inward by 1 cm, then fold it in half, and then wrap it around the clothes.
5) Sew three pairs of hidden buttons on the left and right sides of the clothes, and then decorate the cuffs with lace, thus completing the production of dog clothes.
Material: cotton cloth (50×50 cm), all kinds of fragmentary lace.
Start making the back: first draw half of the back on the paper and cut it out.
Fold the cloth in half, yes, remember that the cloth is slightly larger than the pattern ~
Cut out the back of the extended pattern, preferably slightly larger than the pattern. Look at the photo ~ no matter how small it is, it can't be bigger!
Start making the front film, and cut out the pattern on the paper first.
Check with the back film, it's sewn like this ~
Rear decoration:
Sew the edge first
Decorative bear:
Finally, sew sleeves on the clothes and lace on the collar.
Finished ~ ~ Try it on for the dog, and then set the button according to the most suitable position ~