1, upper left, lower right.
2. Press the left thumb on the back hole (there is only one hole at the back). Next, from the front, counting from top to bottom, the first hole is the index finger, the second hole is the middle finger, the third hole is the ring finger, and the little finger is not pressed.
3. Next is the right hand, four-hole index finger, five-hole middle finger, six-hole ring finger and seven-hole little tail finger.
4. This is fingering.
5. 1- Press and hold all 2- release the right little finger, others press and hold 3- release the right little finger and ring finger, others press and hold 4- release the right little finger, ring finger and middle finger, others press and hold 5- release the right little finger, ring finger, middle finger and index finger, others press and hold 6- release the right little finger.
Other press and hold 7- release the little tail finger, ring finger, middle finger and index finger of the right hand, ring finger and middle finger of the left hand, and other press and hold 1 (add a little more)-press and hold the thumb of the left hand (that is, the single hole at the back) and the middle finger of the left hand, and release the others.
6. This is the fingering of clarinet.
7. Ensure correctness.
The clarinet blowing method:
1, the correct way to hold the flute is to look straight at the head, the flute is at a small angle of 45 degrees with the body, the fingers naturally bend with the left hand up and the right hand down, and press the points with the pulp of the first joint.
2. Don't put the braces too deep in your mouth. The braces are about 0.8 cm in your mouth, so it's best not to point the braces at your teeth.
3. Pay attention to two points when pressing the sound hole. First, point your finger at the soft and fleshy front end. Second, when you press the sound hole, your fingers will naturally relax. Don't raise your fingers too high, so as to avoid clumsy fingering, and don't raise your fingers too low, which will affect the low voice control.