1. What kinds of movable partition walls are there?
1. Assembled movable partition wall: a movable partition wall assembled by light partition wall units, the height of which is the same as or only a part of the height of the room. The partition unit is usually 6 ~12cm thick and 60 ~120cm wide. It takes wood or thin-walled metal profiles as the frame, and plywood, fiberboard or gypsum board are used on both sides. Some also fill the interior with honeycomb paper to enhance rigidity, or mineral wool to improve sound insulation. This kind of partition fan is used in houses and schools where the space separation changes for a long time.
2. Push-type movable partition wall: a movable partition wall composed of a plurality of partition fans that can move along the track. The width of each partition fan is generally 60 ~ 120 cm. The height depends on the need, and the structure is the same as the partition fan with assembled movable partition. There are two kinds of this partition: sliding and sliding. Sliding type, with pulleys at the lower part and grooved guide rails on the ceiling and ground, suitable for heavy movable partitions.
3. Folding movable partition wall: a folding movable partition wall composed of multiple partition fans. There are two kinds: wide fan type and narrow fan type. Wide fan partition is the same as press movable partition. The upper part of each partition is installed on the guide rail with a group of pulleys that can change direction, and the partitions are connected by hinges, which can be folded and pushed into the storage room when not in use. This kind of partition is restricted by many factors, and it may not be easy to push if it is not handled properly, so there is a double folding type, and the two partitions are connected together.
Second, how to install the mobile partition wall
1. The size of the track box at the upper part of the movable partition shall ensure that 12 cm is high and 9 cm is wide. Like curtain boxes, rail boxes are equipped with rails, and movable partitions can be hung on the rails. When the height of the door is lower than 1.95m, people feel depressed. Therefore, when moving partitions, the height should be at least 195+ 12=207 cm.
2. The gold size of a normal door is about 80 cm× 200 cm. Under this structure, the door is relatively stable and beautiful. Therefore, the width-height ratio of the movable partition is close to the size of gold.
3. Carefully use the movable partition (open suspension track box) from the ground to the top. Because the swing amplitude is too large when pushing and pulling, the movable partition is easy to deform after a long time, and the deformed back door can't be opened, which means it can't be repaired and used.
4. When installing the movable partition rail, fix the upper rail, use gravity cones (hanging wire hammers) to hang three points at both ends and midpoint of the upper rail, draw a 3.3-point fixed surface on the ground with oil paintings, install the upper rail, and then put a hanging hammer at the center point of the upper rail to the ground. Vertical lines should be placed at both ends of the track, and the lower track should be fixed at these three points to ensure that the upper and lower tracks are completely parallel, and the push and pull of the sliding door is in the best state.
There are many kinds of movable partition walls, which consumers need to choose according to their specific needs. The installation of movable partition must be in place, otherwise it is easy to break. The above is what kinds of movable partition walls Bian Xiao introduced and how to install them.