Android tablet or Android phone
Networked computer
Usb cable for connecting tablet/mobile phone and computer.
Methods/steps
1
First, find the corresponding official website according to the brand of Android tablet or mobile phone. There are many ways, just search 100 degrees.
After entering official website, we choose "Services and Downloads" and enter your device model in the search box.
There will be many search results. Look at the version number of the tablet or mobile phone (I look at 10, 1 1, 12 digits of the SN code on the back of the fuselage), and then download the firmware program of the brush machine according to the version number. This step is very important. Please be sure to find the right model and version number, or the brush will fail!
Shut down all kinds of antivirus software, all kinds of health services and computers. Then, right-click my computer, select Device Manager, and turn on the universal serial bus controller.
Select USB root directory. Hub ",right-click Properties, then switch the tab to the" Power Management "column in the pop-up menu, remove the check mark in front of" Allow the computer to turn off this device to save power ",and do the same for other" usb root hubs ". Please connect the usb cable to the usb port on the back of the computer, and be careful not to connect the tablet at this time.
Unzip the downloaded firmware program and find the USB-Burning-tool-SPI directory. After entering, find the brush program with the common name of ***burn** (this is the core program of brush machine) and open it.
Select Configure-Import Upgrade File, and then locate the zip file in the previously unzipped folder.
After importing the upgrade file, turn off the power of the tablet computer (if you are not sure what state the machine is in, you can press the reset button briefly to force it to shut down). Press and hold the Home button (there is a small house icon on the button), connect the tablet computer to the usb cable, and then press the power button to turn it on after the battery icon is displayed on the screen. Press and hold the power button for about 4 seconds, and then release the power button and the Home button. If it is the first time to brush the computer, a small window will pop up in the lower right corner of the computer, prompting the discovery of new hardware and requiring the installation of drivers. (Note: The drivers installed on the same computer only run when you brush the machine for the first time; When you brush the machine again, you don't need to install the driver again. ) The extracted directory contains drivers, so follow the steps to install drivers.
After installing the playback driver, the upgrade tool program will find and identify the settings, as shown in the following figure:
After discovering the equipment, click the "Start" button on the right to brush the machine safely. My Android tablet has been brushed for less than 5 minutes, please don't turn off the power during this time!
When the progress bar shows 100% and the brush software as shown in the figure appears, the brush is successful. At this time, click the "Close" button, unplug the device from the usb cable, and turn it on to enjoy the fun brought by the new system!