1, how to weave the ring is as follows: find a red line about 20 cm. If the ring is worn on a big hand, it is recommended to use a thicker one, as shown in the figure. In the following figure, the red rope represents the ring opening and the green rope represents the line around the ring.

2. The knitting method of the ring is as follows: When knitting the ring with rope, you can first fold the red rope in half and tie a diamond knot, leaving a small round head, the length of which is not more than the length of the bead. After that, the diamond knot is repeatedly made to the required length, and then one of the ropes is threaded into the transfer bead.

3. Thread end: 9 strands of 60cm, 0.8*0.6cm for bead turning, red rope folded in half to make a diamond knot, leaving a round head, and the length shall not exceed the length of bead turning.

4. The course of knitting rope is like this: first, put the thread through the left thread from the middle of the loop, and the right thread bypasses the left thread and bypasses the bottom of the loop. Pull out the left double buckle to adjust the tension. The left line is slower than the red line, and it is pulled down from the freshness and loop of the right line. Make a line and tighten a line.

5. Calculate the length to edit. Here, because the knitting method of the bead circle is taken as an example, the length of the bead should be subtracted when calculating the length. After the diamond knot is woven, put in the transfer beads, and the thread passes through the top of the diamond knot. The thread passes through the transfer bead again. Cut off the excess thread for later use. Finally, burn it with a lighter.