1. After the underarm knitting is completed, the sweater is divided into two pieces: the front piece and the back piece. Weave the back piece onto the back collar. Leave 16 stitches and thread.

2. When knitting the shoulder close to the back collar, sew 2 stitches on the left and right. (Knit the left and right shoulders at the same time) Then continue to knit the shoulders and decide the size of the back collar as needed (generally 3-5 rows is enough).

Step 3 knit the front collar. After knitting to the required height, leave 8 stitches in the middle of the front piece at the front collar and thread it. Start with two heads and weave with two balls of thread. * * * Take 8 stitches and weave them to the required length, without adding or subtracting.

4. Sewing the front and rear pieces. After turning to the reverse side, align the two pieces on the shoulders, knit them and sew them.

5. Pick the collar edge and pick a needle for each hole. Pick the collar edge with a fine needle.

The common knitting methods of sweaters are as follows:

1, single side-single machine board is full of needles, left and right triangle control keys are fully opened, and the word code is appropriate. Single side knitting pieces are knitted in a row, and single side needle steps are side by side in the same plane.

2. Siping-two machine boards are full of needles, four control keys are fully open, and the characters are appropriate. Siping is a double-sided fabric woven by two rows of oblique needle boards. The needles of both machine plates are operated, and each row of needles alternately pulls the needles according to their respective aspects. The appearance of the bottom and surface of the fabric is the same, and the fabric is elastic.

3. Tong Yuan —— The two boards are full of needles, and the control keys are opened left and right, with appropriate characters. There are three types of Tong Yuan: General Tong Yuan, Open Tong Yuan and Telepathic Tong Yuan.