After the installation of wet floor heating, the floor heating must be leveled on the road surface, and the aspect ratio is similar to 4 mm Before the floor heating is laid, the heating system should operate normally with the certificate, and the road surface should be completely dry, with the water content not exceeding 10%. Before installing the floor, the indoor temperature should be adjusted step by step, so that the indoor temperature can gradually reach 15-2 1 degree Celsius suitable for installation. Ensure that the temperature of the heating system introduced into the concrete floor does not exceed 55 degrees Celsius.
Common problems in the whole installation process of floor heating floor. Add 0.2mm thick thermal insulation waterproof plastic film under the floor mat, and the plastic film interface is overlapped by 200mm, and the joint sealing strip is tightly sealed. Choose a special carpet for floor heating with fast heat transfer, no deformation and environmental protection; Electric blankets should also be anti-aging and insulated. It is best to choose spc installation method according to the raw materials of foundation cushion, so that the wooden floor is close to the road surface. In addition, it is suggested to lay wooden floors in the direction of side light. On the pavement of geothermal heating system, it is forbidden to kick, nail or open holes on the pavement.
How to maintain the floor heating after installation? After the wooden floor is laid, it is necessary to ensure that the heating temperature of the heating system is symmetrical, prevent the ground temperature in some areas from being too high, and keep the soil temperature controlled as much as possible. It is advisable not to exceed 27 degrees. When using the floor heating system software for the first time or for a long time, it is advisable to obviously raise or lower the temperature at 5 degrees every day, and it is forbidden to suddenly cool or heat. Winter is coming, check whether there is water leakage in successive joints.