Current location - Health Preservation Learning Network - Health preserving class - Activated sludge culture method
Activated sludge culture method
1. At the initial stage of activated sludge culture, the activated sludge is suffocated for 22 hours every day and allowed to stand for 2 hours, then 4 liters of wastewater is discharged and 4 liters of self-prepared water is added;

2. After seven days, the sludge was black, with good settling performance, and the effluent was turbid. The corresponding value was measured, and there was no obvious change during the reaction, indicating that the amount of bacteria cultured was small;

3. After14 days, the sludge was light black, and the interface between sludge and water gradually became clear from the beginning of precipitation. Paramecium, roaming worms, schizoa, tube jellyfish and so on can be observed under the microscope, indicating that bacteria are cultivated with the gradual improvement of biological phase.

4. After that, it runs for two cycles every day, and each cycle is inflated for ten hours and allowed to stand for two hours;

After 5.30 days, the flocculation and sedimentation performance of sludge is good. After the mixed solution stood for half an hour, the supernatant was clear and transparent, the interface between mud and water was clear, and the sludge was yellowish brown. A large number of new bacterial micelles can be seen under the microscope, which are relatively dense, and many active bell worms can be observed. Sludge has strong activity, so the culture stage is considered to be over.