A while ago, the temperature was repeated, so I didn't dare to prune Milan for fear that it would not recover if it suddenly cooled down. Now the temperature is above 15 degrees, you can start pruning Milan, and prepare clean scissors. Milan's pruning is simple. Don't water it for 1-3 days before cutting, just like shaving your head. Cut it according to the general shape you want. For example, my favorite mushroom type is to cut the long branches short and shave them almost into a ball. There are many good branches in Milan. Cut off the weak branches that cross each other and keep the ventilation of the middle main pole. Cut the unnecessary branches to a length of only 0.5- 1 cm. If you want the branches to grow new branches, leave more. Don't water it after cutting for a while. Put it in an indoor astigmatism position for about 3 days, and then water it after the wound heals. Don't get wet or drenched for the time being. After half a month, you can pour the nutrient solution, which costs a lot 1 or Olu 5, just choose the same one. Milan will recover quickly after pruning in May, but it should be noted that new branches sometimes grow unevenly. If the new branches are too thin, they can be cut short to prevent excessive growth or deformation. Control the shape of round mushrooms and increase the light, which can be outdoors. In this way, Milan will bloom around June, and the number of flowers will be several times more than before. Almost every branch has buds, and it is still very fragrant. Figure: X 10 17:

Chinese rose

The roses in May are basically blooming for the first time. Cut it off in advance after this flowering, so as to preserve nutrition and make the second flowering faster and better. First, cut off the residual flowers. The first rose doesn't have to wait until it is in full bloom. You can cut it if the pattern is normal. After cutting, you can also put it in a water bottle to watch, and you can also preserve nutrition for the mother plant of Chinese rose. The cutting method of this rose should be tough. After each flowering, the branches with many buds should be cut off in time. When all the buds are in full bloom, cut 3-5 leaves from the top of the bottom of the branch; After a single flower is in full bloom, there are 3-5 leaves directly from bottom to top. The general cutting method is diagonal cutting at the bud point of 45. Don't leave too much, don't cut too hard, and leave too little. The right side of the picture below is the correct cutting method with moderate length. Besides cutting off the flowers, we should also cut off some branchlets and blind buds. Branchlets are thin-looking branches with no climate. Cut them off. Blind branch, with only one leaf at the top, no bud point and no flower bud at the later stage. 65438+ 0-3 days after pruning, the wound is slightly dry, so you can water it, fertilize it a week later, or bury 2-3 handfuls of cooked sheep manure along the basin. It is not advisable to put manure or thick manure. If the flowerpot is too small, you can simply exchange it for a bigger one. Don't cut the roots, it is safer to change the original soil. Photo: Blueberries and MengMeng: From May 20 10 to May 20 10, raising geraniums is a bit like walking on thin ice. In many areas, the occasional high temperature can exceed 30 degrees, which is very dangerous for Xiaotian. It is easy to rot at high temperature and needs pruning and slimming. Many angry people are still in a state of bared teeth. If bloom eats too much, cut off the residual flowers and stems first. The knife must be disinfected, otherwise the incision will be infected by bacteria, and there will be a risk of black rot and yellow. In addition to cutting off residual flowers, it is also necessary to cut off too dense branches to keep the plants ventilated and fresh. Old yellow leaves should also be pinched off. In fact, it is a simple change from complex to simple. Be careful not to over-trim. Pruned branches can also be cut with sand for later use. Put the cut branches in a ventilated place and water them when the wound is dry. Pay attention to shade in hot weather and water it in the morning and evening. Don't water it too much. What you like to do. Not all geraniums will start to spend the summer after pruning. If the environment is suitable, such as cloudy days and astigmatism in the northeast, Xiaotian may continue to grow and blossom. You can sprinkle some Euro5 fertilizer in the basin.

The new and old branches of bougainvillea will bloom, and some old branches may open bigger. Cut off short branches and keep each branch with enough light, so as to ensure that all branches will bloom. Do not water after cutting, but water after drooping leaves. Every time, the leaves droop and water. This maintains the water control state. When small buds appear near the bottom of leaves or new buds appear at the top, stop controlling water and start watering normally. When the soil is dry, water it in time to ensure that flowers bloom all over the branches. In addition to pruning those that do not bloom, you can also prune those that are unsatisfactory, such as the picture below. There are no rules. Pruning is very simple, that is, cutting the prominent branches short to make the whole more harmonious. Control the water after cutting, or add some flowers to Duoduo No.2 when watering. Soon, the old pile will be full of flowers. Bougainvillea is very active. If no pruning pressure is applied, it will grow loosely and bloom more densely after pruning. Practice more and you will find the feeling.

pelargonium

In spring, I bought a man named Qiu Hua at the flower market. After Bloom died, he turned yellow. Many people think that if they put it here, they want to throw it away. In fact, a wound can continue to bloom. Photo: Xia Xiaole 27 actually cut off the bad part and the yellow part, leaving only the solid part at the bottom. Do not water after cutting, pay attention to ventilation. After about 2-3 days, the water along the basin and new leaves will appear soon. Chrysanthemums are mostly clustered. After cutting, they will not only grow new leaves, but also grow more foot buds. After cutting for half a month, you can sprinkle some slow-release fertilizer on the basin surface. After one month, you can pour quick-acting fertilizers, such as flowers and nutrient solution, every 10 day, and they will sprout and bloom soon. After the buds grow out, gradually increase the light. You can also apply fertilizer in the early stage, but it should be light, otherwise it will burn buds. When the bud is colored, immediately stop fertilization, keep the light and wait for the bud to bloom. In this way, the family can also raise the effect of the flower market. Isn't it amazing? All kinds of men named Qiu Minghua, Medal Chrysanthemum, Table Tennis Chrysanthemum, Thousand-headed Chrysanthemum, Millet Chrysanthemum and Ji can operate according to this method ~ Xia Xiaole photo 27

Phyllanthus

. Don't dislike Petunia, it can't grow, it can't bloom many flowers, and you can't bear to let the children let the wolves go. Petunia must be pruned more. Don't be greedy for the first flower, cut it off if it blooms too little, and the second flower will start to burst. If you think there are few flowers in the first crop, cut them directly from 1/3 of the floor cloth. Many flower lovers are reluctant to part with it. Be mentally prepared, take a deep breath and use scissors, and you will become more and more addicted. It looks like the picture below after cutting. There are only a few thick stems left. Don't water it after cutting for a while, and then water it after 1-2 days. Water it along the edge of the pot and it will sprout soon. After cutting for about half a month, new buds will basically grow. At this time, you can sprinkle some slow-release fertilizers. Beginners should not pour quick-acting fertilizer, there is a risk of burning seedlings. After 20-40 days, the second crop blooms ten times more than the first crop. After the second crop of flowers, you should continue pruning. When pruning the residual flowers, you should also cut off the long and messy branches. Petunia is very resistant to pruning and can only live on poles. After this repeated pruning, the third or fourth time is the state of explosion. Petunia can bloom in autumn and winter, and will continue to bloom in winter above 15 degrees. By the way, the cut branches can also be cut, and it is easy to become a big family ~

Anjyou Naruko

. Rhododendrons will bloom in spring, especially the small rhododendrons we often buy, which are mostly in the west and can bloom in many seasons. Every time you cut it, it will continue to sprout. However, there are tricks to pruning azaleas after pruning. If you cut hard, the recovery period will be long and you won't cut enough. Look carefully at the picture below. After azaleas are in full bloom, if only the residual flowers are removed and the flower stalks are kept, they may continue to consume nutrients and develop into seeds. Therefore, after the azaleas are cut, it is best to cut them together with the flower stalks. Don't cut the leaves and branches at the top. All azaleas will grow.

Rhododendrons also like light, but they can't be exposed to strong light for a long time, especially on hot days. When the temperature is higher than 28 degrees, pay attention to shade. 2-3 hours in the morning is enough and the environment is suitable. Rhododendrons can also bloom in many seasons.

Petunia

The upside-down golden bell also needs pruning from time to time. Pruning will make it grow more luxuriantly and control the branches not to grow too long. Plants will be stronger and less prone to wither. When the golden bell blooms upside down or does not bloom for a long time, the top of the branch can be cut off 1/3. Scissors must be disinfected in advance, otherwise the wound will be prone to black rot. Don't water it for the time being after cutting, keep sufficient ventilation, and then water it after drying. Golden bell flower is a flower with short sunshine, which likes warmth but is afraid of sultry. It is best to put it on the window sill with astigmatism, and the temperature is between 15-26 degrees. It will soon grow new branches. Fertilization can begin after about 1 month. If the temperature is not suitable, don't fertilize. When the temperature is between 15-26 degrees, the upside-down golden bell can continue to bloom after cutting. If it is too hot or too cold, growth may slow down. At present, the temperature varies greatly across the country, so it is best to adjust and maintain it according to the local climate. If the temperature is too high, higher than 28 degrees, it is necessary to prune and shade. It is better to move to the north windowsill for ventilation. If the branches are too long and dry, cut them off in time. Sprinkle carbendazim after cutting, put black rot water, and put a basin of water next to it for humidification. If you are worried that you will die in summer, you'd better cut more branches and use clean vermiculite or perlite and sand to cut them. The cut seedlings are easier to spend the summer. Every time a dozen trees are cut down, there are always a few trees that will survive and be prepared ~ Photo Author: Normal mind