1. Unscrew and remove the three bolts that fix the startup disk on the machine body, rotate the machine body and remove the startup disk.

2. Turn the starting reel upwards to untie the remaining knots or rope segments wound by plastic rope on the reel.

3. At the beginning of installation, burn the rope end at the end of the rope winding disc with open fire, then pass the wire or thin iron wire (10- 15 cm long) through the rope hole of the plastic rope winding disc, rotate the plastic disc to align the rope hole with the rope hole of the iron disc of the starting disc, and make the wire or thin iron wire pass through the rope hole of the iron disc.

4. Tie the charred end of the rope with thin iron wire or thin iron wire, then pull the starting rope along the perforation, and one end passes through two holes, so that the starting rope enters the square hole of the rope burying head of the rope winding disc, and then pull out the knot and insert it into the square hole.

5. Insert the end of the rope into the groove on the rope winding plastic disc, press the rope in the groove with your left hand, and turn the rope winding plastic disc counterclockwise with your right hand. When the disc rotates, the pull rope will also rotate with the disc, but it will not wind around the disc until it can no longer rotate, indicating that the starting spring inside has been tightened. Then, release the starting rope from the groove on the disc and slowly loosen the rope winding disc, so that the rope will follow the plastic disc. At this time, the rope reel will rotate clockwise. Until the rope is full of knots, I hope I can help you.