1, create a new blank document with the width and height as shown in the figure and filled with blue.
2. Ellipse tool, pull out a circle at the bottom to select and feather, the value depends on, fill with white.
3. Create a new layer (just say "New" later) rectangular box selection tool, pull out a long rectangle in the middle and upper part, and fill it with yellow.
4. Drag the model, add a white mask and erase the edges with a black soft corner brush.
The same goes for shoes,,,
5. For the bottom photo, drag the photo below the layers of these two shoes, double-click the photo layer to pop up the layer style, and select the strokes.
6. Draw the following shape with the rectangle tool.
And this.
The picture on the blue square is handled in the same way as the photo just now, and () is omitted.
7. Create a new question mark on the yellow square, and you can use the custom shape tool. If there is no question mark picture in the custom shape tool, you can draw it with the pen tool, or download the question mark picture online, and then make a projection of the question mark.
Double-click the question mark layer, layer style-projection, and the value is customized. . . .
8. For the gray bubble at the top, the method is the same as drawing a rectangle. Use the ellipse tool () to omit ().
9, the rest is typing,
10, forgot to lift the clouds on the shoes,,,
Download the cloud material, dig it out, (method defined), put it on,
1 1. Create new, select 14 brush, and draw points on the back of shoes.
12,, select the dot layer, take the dot as the center, pull out the circular selection (using the ellipse tool), select the filter-blur-radial blur,, the blur mode is zoom, the value is customized,, cancel the selection after confirmation, select it, put it in the appropriate position, and modify the inappropriate place with a brush.
13, it's over,,, I'm exhausted from playing so much, and I still need to draw screenshots,