If you want to get rid of the fat on your body, a fitness artifact elliptical machine is essential. Under normal circumstances, elliptical machines purchased in physical stores are delivered to your door and installed, while elliptical machines purchased online are not necessarily. Below I will bring the installation details to those friends who buy fitness artifact elliptical machines online. I hope you can lose weight soon.

First, install the tool.

In general, the elliptical machine purchased online comes with installation tools, but you can also prepare an L-shaped screwdriver for standby.

Second, the receiving inspection

Check the spare parts of the elliptical machine according to the installation instructions of the elliptical machine, check whether there is any omission or damage, and contact the merchant for replacement in time if there is any.

Third, install the base.

The base of the elliptical machine is divided into a front underframe and a rear underframe; Installing the base is very simple. First, you can use something to pad the corresponding part of the base installation, and then install the base on the elliptical machine with screws.

Fourth, install the trunk

The spine of the elliptical machine is equivalent to the lifting rod of the head of the spinning bike, which plays the role of supporting the handrail and the control panel. When installing, pay attention to straighten out the wires inside first to avoid being entangled, otherwise the control panel will not start. You have to take it apart and put it back on.

Verb (short for verb) Install handrail.

Fix the handrail in the specified position, and pay attention to tighten the screws during installation; Different brands or models of ellipses have different shapes and structures, so the location of spare parts can be judged according to the installation effect diagram in the manual.

Six, install the pedal

Pay attention to tighten the screw when installing the pedal, and put the nut at the bottom.

Seven, install the control panel

Connect the wiring as required, then tighten the screws from the back and install the black back cover.

Eight, after loading inspection

Check whether the screws of each interface are loose or missing, and then power on the test after troubleshooting. Turn on the power supply, test the control panel, and check whether the display and buttons work normally. If there are no exceptions, the installation is complete.

Note: different types of elliptical machines have different structures, so the installation should be completed correctly in combination with the instruction manual and the installation video content in actual operation.