Family sauna room design must pay attention to two aspects, on the one hand, sauna room insulation, on the other hand, sauna room ventilation.
Attention should be paid to the thermal insulation design of family sauna room: the walls, ceilings and doors of sauna room should be well insulated. When calculating the power demand of electric heater, the uninsulated surface per square meter will increase by about 1.2 cubic meter. The sauna room should be properly moistureproof to prevent moist gas from entering other rooms or wall structures, and the moistureproof device should be installed between the heating insulation layer and the slats.
However, attention should be paid to the ventilation design of family sauna: hot air and cold air should be mixed in the sauna room in an appropriate proportion. Another reason for ventilation is to absorb the air around the electric heater and transfer the heat to the far end of the room. The position of the vent can be adjusted according to the design of the sauna room and the preferences of the owner. The air inlet should be directly arranged on the wall below the electric heater. When forced ventilation is used, the air inlet should be set 60 cm above the electric heater or on the ceiling above the electric heater. It is suggested that the size of the air inlet is 5- 10cm, and the air outlet is set at the diagonal position opposite to the air inlet. It is suggested that an exhaust port should be set under the platform of sauna room, and it should be as far away from the exhaust port as possible. The exhaust port can be set near the floor, or it can extend from the ground to the vent under the ceiling or door of the sauna room through a special exhaust pipe.
The heat insulation and moisture-proof devices in the family sauna room should be installed and designed from outside to inside in the following order. First of all, the thickness of wall insulation layer is not less than 50mm, and the thickness of ceiling is not less than100 mm. Secondly, it is best to use cardboard boxes or aluminum foil as steam barrier and install it above the insulation aluminum foil. Then, leave an air gap of at least 20 mm between the steam barrier and the internal slats. Finally, in order to prevent moisture from accumulating behind the slats, a groove should be left between the slats on the wall and the ceiling.
These are all matters that should be paid attention to in the design of family sauna room. If you need to install a sauna, remember to consider the ventilation and insulation mentioned above when designing. Imagine that if there is no ventilation, people will suffocate and even become dangerous in the sauna room, so they will not teach sauna. Generally speaking, the advantages of home sauna outweigh the disadvantages. If everyone is excited, we can install a sauna at home.
Tubatu Online provides you with "every decoration quotation, 1-4 local decoration companies, 3 sets of decoration design schemes" and the decoration pit avoidance strategy for free! Click this link:/Zhu Ye /zxbj-cszy.php? to8to _ from = SEO _ zhidao _ m _ jiare & amp； Wb, you can get it for free ~