If you choose the existing wallpaper stickers for residential decoration, you can only make putty powder without painting. This is the process of residential decoration! First of all, the existing building can be repainted and rebuilt, and the wall surface can be updated according to the following steps: 1, wet wall: the wall surface is original, so it takes time and energy to shovel. ? 2. Decoration and wall treatment of residential houses, as well as peeling of walls: remove a part of the original submerged walls until the cement mortar wall or putty layer is exposed. ? 3. Interface agent: the wall surface is painted with coating agent, which must be brushed and brushed. ? 4. Cracks and seams: Kraft paper tape and white latex are generally used to bond seams. ? 5, flat, flat: uneven walls should be flat. Gypsum is common, and the concave-convex difference is less than 0.5cm? 6, paste, cloth paste: If there are conditions to crack the relative effect, generally require hot stickers such as light wall and non-load-bearing wall, try to choose a better white latex wall will be better. ? 7. Batch putty: It is best to use high-density and hard putty, or you can add specific white latex to the putty to improve the hardness of the putty. Try to use fine sandpaper, usually soft putty. If the sandpaper is too thick, it will leave a deep sand mark and cannot be covered with paint. The polished wall must be thoroughly cleaned to avoid too much dust and affect the adhesion of paint. The unevenness shall not exceed 3mm. Residential house decoration and wall treatment? Floor and paint: If the primer eats a lot of paint on the wall, it should be brushed evenly, and the wall should also be brushed evenly, so it is best to give a small amount of water to the primer. I don't think it will use the same texture as the paint bucket, because it is the primer of roller brush, which will produce the effect primer and directly affect the finishing effect.

Decoration of the living room wall treatment 1, looking for a supplement: it is difficult to see what putty is after polishing, and some defects will be left. ) In general, it is prudent to repair it until you are just a paint brush. This time, please smooth the brush and apply some water, because the water consumption is different from other walls, and the paint will not be colored. ? (1 1), paint surface: the handle affects the film that is not replenished in time, and the hardness of the film is better, so try to choose the thickness of the film brushed with a short-haired roller, but it is necessary to brush out the slimming protagonist and the middle rod direction, process angle, pen or brush with good handle for the accommodating part. When most of them are in the scrubber, the corners are easily different there, which leads to the inconsistency between the whole surface and the visual texture. Then the material surface and roller brush surface always brush the roller surface at the corner of the washing roller, and it is too thin to brush it again after paying close attention to seven beautiful paints, otherwise the paint collected by reflective paint roller on the wall will be consistent. After each rolling reception, the uniform thickness of the reception should be one, and the rolling direction must be the same each time. Otherwise, the textures of each volume will not match, and the reflection angle will change, resulting in different visual effects. ) Use a tray to put each brush on the plate. Brushes are because the rollers are the same. ) 12, protection: After the latex paint is dried for 4 hours, the dried paint film cannot reach a certain hardness, so be careful. It's simple. Do not wipe or touch the wall for 7- 10 days.

Tubatu Online provides you with "every decoration quotation, 1-4 local decoration companies, 3 sets of decoration design schemes" and the decoration pit avoidance strategy for free! Click this link:/Zhu Ye /zxbj-cszy.php? to8to _ from = SEO _ zhidao _ m _ jiare & amp； Wb, you can get it for free ~