Because the wall-breaking machine has high power and high rotation speed, the heat generated will also be high. Therefore, the single use time of the wall-breaking machine should not be too long, otherwise it will cause the body to overheat and cause downtime. The specific fault of e 19 is that the temperature in the cup exceeds 80℃. If it continues to run at this time, it may cause the liquid in the cup to boil and splash, causing unnecessary trouble. At this time, you only need to change the ingredients in the cup to normal temperature, or add cold water to reduce the temperature in the cup, which can be solved.
Pay attention to adding water when using the wall-breaking machine. Some programs need water to start, and some menus have water requirements. Too much or too little water can cause problems. The wall breaker also has its single tolerable food capacity. If you add too much food, it will also cause the machine to report an error and not run. You can use the randomly given measuring cup to quantify the ingredients to ensure smooth operation.
Common fault codes of wall-breaking machine
1, E 1: This fault code is usually caused by the problem of motor power supply voltage. Judge whether the voltage meets the specifications. If yes, it is recommended to check whether there is any problem with the motor connector and the motor itself, which needs to be replaced or repaired.
2.E2: This fault code may be caused by overvoltage or capacitor fault. At this point, you can check the wiring or replace the capacitor.
3.E3: This fault code usually indicates that the power supply of the main part of the wall breaker has failed and needs to be replaced.
4.E4: This fault code means that the motor is overloaded, the pulley is wound or the motor coil is faulty. Need to adjust the size of the motor load, check whether there is a short circuit problem in the motor coil, and need to be repaired or replaced.
5.E5: This fault code may be caused by a power supply voltage fault, and the voltage needs to be adjusted.
6.E6: This fault code usually indicates that the main body of the wall-breaking machine is overheated and needs to wait for a period of time before using it.
7.E7: This fault code may be the fault of the main circuit of the broken wall, or the fault of the capacitor or power supply, which needs to be checked and repaired again.
8.E8: This fault code indicates that the main circuit of the wall-breaking machine has failed and the control module or circuit board needs to be replaced.