Indications: pry the wooden floor after soaking in water.
Solution: For the flooded floor, try to keep the wooden floor from deformation.
It is very important to dry in the shade. After the moisture on the surface of the wooden floor is dry, it can be stacked in a "well" shape to prevent deformation due to the weight generated by stacking. Pay attention to the reverse side of the wooden floor when placing it to prevent the surface from cracking due to rapid drying. At the same time, be careful not to be exposed to the sun, and put it in a ventilated place to dry in the shade. Generally, it can be reused for solid wood flooring and multi-layer solid wood flooring with good quality. In addition, once there is water leakage, it is necessary to inform the after-sales service office of the wooden floor at the first time, and the staff will provide the best solution for the owner in combination with the situation of the wooden floor itself.
Option 2: Remove the baseboard.
Indications: Flooring strengthened by immersion.
Solution: No matter whether it is a large area of soaking water or a small area of stagnant water, Mr. Liu does not recommend prying open the laminated wood floor to dry, which may easily cause damage to the laminated wood floor and may cause serious consequences that it cannot be used again. It is best to drain the surface water of the floor quickly, then take off the baseboard of the floor to expose the expansion joint, and rely on the expansion joint to dissipate water vapor. But according to the size of the water, it usually takes about seven to fifteen days to dry. For products with good quality or short soaking time, they can be recovered by themselves. If/kloc-cannot be recovered after 0/5 days, it should be replaced again.
Option 3: pry open the ventilation on both sides while leaking water.
Indications: solid wood floor with keel, small area soaking.
Treatment plan: if a small area of water is found in time, you can clean up the ground, pry up the board, dry the wet floor and reinstall it; If the water inflow is slightly larger, not only the board at the leaking place should be pried up, but also the opposite board should be pried up along the keel arrangement direction to let the circulating air inside take away the water. If you can't determine the size of the water inflow, it's best to pry up the boards in turn to check the humidity according to the flow direction of the water inflow, so as to be foolproof.
Option 4: use a high-power vacuum cleaner to suck.
Indications: The solid wood floor is directly laid with small area of water.
Solution: If water is found in a very short time, you can use a high-power vacuum cleaner to suck out water vapor. But if a large area is flooded, pry all the wooden floors up and dry them in the shade according to the second scheme. At the same time, if the indoor humidity is high and conditions permit, a dehumidifier can be installed indoors, which can drain the indoor humidity in a short time, but this operation scheme requires wood floor drying identification technology.
The above is the answer to your question from Ou Pai Floor. I hope it will be adopted. Thank you!