1. First of all, you need to prepare two towels, one can be placed under the exhaust hole and the other can be placed at the water outlet to prevent water from overflowing and wetting the sheets. You also need to prepare water pipes and screws.

Secondly, take out the bedspread, unzip it, lay it flat on the bedside, and lay a layer of bedding under the bed. Then take out the capsule and put it flat in the bedspread. The two water inlets should be upward and the direction should be adjusted at the same time. Connect the thermostat with the internal wire, put the connector outside through the bedspread, and open the water injection place.

3. Finally, insert one end of the water pipe into the water inlet, then start water injection, then lay the other end flat on the bedspread, align as much as possible, then turn on the power supply, pull the zipper of the bedspread, and complete water injection.