1. installation: first connect the hot and cold water pipes of the bed washer (generally choose No.20 hot melt pipe as the water pipe), and then connect the drain pipe (generally choose No.50 cold water pipe).

2. Electricity: The fumigation pot and the thermostat need to be connected by two trident holes.

3. Drain water: plug the drain at the bottom of the shampoo basin with a soft plug, then turn on the shampoo shower and pick up a proper amount of warm water (the water temperature is slightly higher than usual). The total amount of water is about the height of a palm, just below the bottom of the shampoo basin (note: too high is a waste of water, too low is easy for the pump to intake air).

4. Start: The control panel is located in front of the washbasin and has three buttons, namely, switch, temperature and timing. After releasing warm water, it is confirmed to be normal.