1. First plug in the power cord, cover the health pot and put it on the base, then turn on the switch. Remember not to turn on the switch of the health pot and put it on the base of the health pot.

2. Next, in the standby state, press the "Function Selection" key to select the function to be used and press. It will automatically enter the working state after 3 seconds. The digital tube will display the measured water temperature and heat it to boiling at maximum power. The digital tube displays "End", and the indicator light flashes to end the working state.

3. When heat preservation is needed, press the heat preservation switch, the heat preservation indicator light will be on, and the health pot will start to keep warm. When heat preservation is not needed, press the heat preservation button again, and the heat preservation pot will stop heat preservation, and the heat preservation indicator light will go out.

When it is used for the first time, you need to pour clean water into the pot, and the water level must be about 0.5cm higher than the heating element at the bottom of the pot, and then turn on the power. If there is a model with fast and slow gear function, it can be set to fast gear. At this time, the health pot will automatically heat to boiling until the water evaporates below the heating element, and then it will automatically stop heating and emit a green light. It should be noted that if the health pot is automatically closed before the water is boiled, there may be too much scale in the health pot, which can be solved by removing the scale.