In order to be the most like a doorway, come up with the following wall climbing scheme. ?
Just bought it, it's like a doorway, but it's not like enough. ?
See the final result first? , as follows, more like a doorway.
The perfect wall-mounted installation scheme is as follows:
1。 Remove the baseboard?
My baseboard was glued with foaming agent, and an air nail was removed with a screwdriver. Relatively easy. Try not to damage the skirting line and wall surface. If the wall is broken, remember to repair it? All right. Repair with putty and latex paint.
2。 Measurement:
Measure the highest point of the wire rope behind. ?
The highest point of the wire rope of my mirror is 184cm. ?
I forgot to take pictures. The picture below is a schematic diagram of the back of the mirror, and the red line is a steel rope.
H represents the height from the highest point of the wire rope to the bottom of the mirror.
3。 Determine the drilling height:?
Because the wall is not a load-bearing wall and the mirror is heavy. For the sake of safety, it is hoped that the mirror will not be completely suspended, and the weight of the mirror will not be completely borne by the expansion screw. I hope the mirror can just touch the floor, so that the floor can bear the weight of a writing, and at the same time it can be hung straight. ?
Therefore, the drilling height is very important, which should be measured and confirmed in advance. ?
4。 Drilling:?
The expansion screw provided by the seller needs to be drilled with a 10mm drill.
Below: IKEA electric drill with 10mm drill bit? Punching in is too easy.
After drilling, insert the plastic sleeve of the expansion screw first, and then screw in the screw. The screw is not screwed completely, and the screw head protrudes about 5mm from the wall, which is used to hang the metal lanyard. ?
5。 It takes two people to hang the mirror. ?
The actual drilling height will not be so accurate, and it is difficult to ensure that the mirror just hangs to the ground. ?
After hanging the mirror, it was found that the expansion screw was about 4mm high, which caused the mirror to hang completely. I just bought some metal characters. I'm going to put it on the left and right sides under the mirror. ?
The thickness of the mirror is 2.5cm, the width of the corner code is about 2.0cm, the length is over 90 mm, and the thickness is 1.5mm and 2.0 mm ...
There was something wrong with the mirror before, so I changed it again. ?
The highest point of the steel wire rope of the new mirror is about 186cm, which causes the expansion screw I played before to be too short about 1.5cm?
6。 Twist the wire rope to adjust the height. ?
Because the expansion screw is short, the mirror is completely hung on the floor and can't be hung straight. In order to make the mirror hang straight on the wall and floor. The method of hanging rope with twisted steel wire is adopted. ?
Two people cooperate, one carries the mirror and the other adjusts the number of laps. Try several times and gradually increase the number of turns until the mirror just hangs on the wall and on the floor. ?
7。 Measure and cut the skirting board.
After the skirting line is cut, clean up the foaming agent remaining on the back and wall of the skirting line. If the wall is damaged, repair it. ?
8。 Installing skirting board
Finally, install the skirting line with foaming agent. ?
Skirt detail
Details of the baseboard?
Important notes:
Don't make the hole high, because it is very troublesome to make the corner code high and then stick it with silicone.
You can lower it a little. After lowering 1.5cm, it is relatively simple to adjust the height of the mirror by manually twisting the wire rope.
This answer comes from the user's short-legged big-faced cat, more decoration strategies and home experience. Welcome to the live APP.