Let me measure the width between these two piers first. The three steps are about 2.7 meters, which is equivalent to the width of the gate.
Step by step, the width of the corridor is about 4.5 meters, and a road cone is placed at a position of about 4.5 meters as a temporary boundary. Let's see if a 5.3-meter-long vehicle can turn into the gate when the aisle is 4.5 meters and the gate width is 2.7 meters.
Vehicles come from the aisle, turn left and make full use of the maximum width of the aisle.
From the other end of the aisle, you can see that the vehicle is driving to the left side of the vehicle, so that the left wheel can drive close to the left shoulder and the width of the aisle can be used to the maximum extent.
When the right rearview mirror is roughly aligned with the pier, it will be full to the right.
At this point, observe the right window, and the driver's line of sight just sees the right door pier.
When the direction is fully turned to the right, continue to turn slowly to the right. Pay attention to alternately observing the front and rear rearview mirrors, and you can still see the left pier at the lower edge of the front windshield.
Keep turning to cover the dock. No problem, you can turn over.
Look positively at the turning process. Keep the direction to the right and continue to turn right.
You can see that the vehicle rolls over slowly, and the left front corner of the front of the car is very close to the pier, almost rolling over at the limit distance.
Let's look at the space on the right side of the car body from the pier. Ok, now the turn is successful.
To sum up, the reason why I can turn it over this time is to make full use of the width of the aisle and turn left at the beginning, occupying a width of about 4 meters;
Second, the right timing is more accurate. If it is late, the left front corner of the front bumper will scrape to the left pier.
However, when we finally turn in, the space between the right car body and the right pier is a bit large, and there seems to be room for improvement. Then let's try to challenge a closer distance.
Vehicles drive along the middle of the aisle and try to keep the left and right spaces of the aisle consistent.
From the opposite side, you can see that the vehicle is right in the middle of the aisle, and the left side of the car body is about 1. 1 m from the shoulder.
The time to make up the right direction is a little earlier this time. When the right front wheel is aimed at the pier, turn right in all directions.
You can see the position of the pier from the lower right corner of the front windshield inside the car. As you turn right, the pier moves to the left until you can still see it in the middle of the lower edge of the front windshield, indicating that you can turn around.
But at this time, you can't see the lower pier from the right rearview mirror.
Go a little further. In order to prevent scratches, I put my hand in the neutral position of the brake and got off to observe. Whether it's an old driver or a novice, get off the bus and observe at a critical time, and don't feel humiliated. Scratching will really lose face. Get off the bus and observe it once.
When you get off the bus, the distance from the front corner of the bumper to the pier is consistent with the judgment, so you can pass, and the distance from the right car body to the pier can also pass.
Now, when you get back to the car, you can safely turn right and come in. You can see the left front bumper. Turning around is still so extreme.
However, the right side of the car body is much closer to the pier than last time, and the right rear wheel turns almost at the limit distance from the pier.
In the right rearview mirror, you can already see the process of the right car body turning inside the pier.
By turning right twice to enter the gate, let's sum up:
First of all, we can make the best use of the road width. In the case of good pavement width, you can turn left near the left limit position, enlarge the turning radius and enter the door calmly.
Secondly, if the width of the road is limited, or there are obstacles on the left side of the road, you can also use the available conditions to turn right earlier within the available width range and make full use of the width of the gate, so that the entrance can still be completed;
Third, if you are not sure, you can't turn right blindly. Get off and observe if necessary. The first thing to observe when getting off is to remember the neutral handbrake to prevent the car from slipping.
Finally, I would like to remind you that the vehicle I used for demonstration is 5.3 meters long and 1.8 meters wide, which is slightly larger than the size of ordinary family cars. This car can pass, so can your car, but because of the different models, heights and sitting postures, please measure the specific points before using it.
This article comes from car home, the author of the car manufacturer, and does not represent car home's position.