Is the digital meridian physiotherapy instrument useful?
Any electrical appliance will emit radiation after being used for a long time, and this digital meridian therapeutic instrument is no exception. If dizziness or poor mental state occurs during use, it is recommended to stop using this product, which shows that its radiation is quite large and it is definitely harmful to the body.
For people with pacemakers, do not use such products. Because it is charged, it may affect the pacemaker, and it is recommended not to use it.
Many people think that using digital meridian physiotherapy instrument is like being shocked, so it is unnecessary to use it. Originally, the digital meridian physiotherapy instrument was a functional product to relax muscles. If you feel uncomfortable, you will not achieve the original purpose.
For people suffering from cervical spondylosis and lumbar disc herniation, the use of such products is almost ineffective. Don't be superstitious about it It is much more useful to cooperate with traditional therapies such as acupuncture, Chinese medicine and massage. The prevention of digital meridian physiotherapy is greater than the treatment.
Whether this has any effect varies from person to person. Some people say that after using it, it can really relieve fatigue, reduce physical pain, and adjust people's mental state well, thus achieving the effect of health care. However, some people find it useless after using it, and they still feel uncomfortable the next day after using it, as if they were fully charged. Most of these products are preventive and health care products, which are not suitable for therapeutic products and have little effect. Remember to buy it in a regular shopping mall and use it according to the instructions.
How to use digital meridian physiotherapy instrument
1. Turn on the power: Press the ON key, the LCD screen will open, and the massage mode indicator arrow will point to the acupuncture mode. At this time, the intensity is 0, and the timing is 15 minutes.
2. Select Chinese and English display: Press the Chinese and English display key, and the display screen can be converted to Chinese or English.
3. Select massage mode: press the function selection key to select acupuncture/thumping/massage/cupping/massage/scrapping/slimming/immunomodulation in turn.
4. Adjust the strength: press the strength adjustment key to adjust to the appropriate strength.
5. Timing selection: you can select minutes, and each time you press it, it will increase by 5 minutes.
Matters needing attention of digital meridian physiotherapy instrument
(1) electrode shall be used at the same time, and the protective film shall be torn off before use. Remember that two electrodes should not touch each other with electrodes to avoid short circuit after adhesion.
(2) Electrode pads made of silica gel will age, so make sure the skin is clean and sweat-wiped before each use. After use, stick a protective film in time, do not get dirty, and stay away from direct sunlight and damp places to prevent aging and prolong service life.
(3) During the treatment, some people feel that the dual-function therapeutic head is strong or weak, which is caused by different nerve distribution and skin sensitivity in different parts of the human body, or insufficient contact between the patient's skin and the dual-function therapeutic head. Then wipe the neck skin with a warm and wet towel 1 ~ 2 minutes before treatment, and treat it when it is just about to dry, so as to ensure that the neck skin is in full contact with the dual-function treatment head (if the neck skin is damaged, use it after the skin is completely healed).
(4) There is no power output after the dual-function therapeutic head is electrified: check whether the time and intensity on the control panel are set (the instrument will start working only after the time and intensity are set); If there is still no output after setting, it depends on whether the system is plugged into the host, and it is necessary to connect the patch panel and wires. There is no output after plugging in the system, which belongs to the internal fault of the host and should be returned to the factory for maintenance.