The method of tying the spiral shoelaces not only makes the long shoelaces look sloppy, but also always faces the trouble that the shoelaces are scattered from time to time. The method of tying the spiral shoelaces is more beautiful. Next, I'll take a look at the relevant information about the winding method of spiral shoelaces with you

Spiral shoelaces in circles 1 Pick up the shoelaces on both sides with both hands, open the thumb and forefinger of both hands, hold the shoelaces on both sides with other fingers, and then pull them with both hands crossed.

At the same time, hold the shoelace with the thumb and forefinger of both hands in the same direction, and then hold the shoelace held by the other hand with the thumb and forefinger at the same time and pull it in the opposite direction. Adjust according to the required tightness.

Take the right shoe as an example. Thread one end of the shoelace from the hole in the lower right corner to the hole in the upper left corner. Leave the length of 15 cm in the upper left corner and a little longer in the lower right corner. Then put the lower right corner into the hole in the lower left corner, and then put it on from the toes in turn.

Extend the index finger and thumb of both hands, wrap the belt around the two fingers clockwise with the left hand and counterclockwise with the right hand. The left and right hands are opposite, the index finger hooks the belt of the other hand respectively, and both hands pull; Overlap the two straps of your hands, cross the straps, and pass the lower strap through the "hole" like a common knot to adjust the shape.

Spiral shoelaces are tied in circle 2.

0 1. Tie the shoelaces in the usual way, and then bend them at the ends. The length of the bent shoelace needs to be selected according to the length of the shoelace, generally bending at one third of the remaining shoelace.

02, according to the way of winding, on the point of shoelaces. At the bottom of the position where we just bent, we circled upwards. It should be noted that when we turn around, the tightness should be appropriate. Too loose or too tight will affect the beauty of shoelaces.

03. Continue to turn upward in the same way, leaving a small hole at the top of the shoelace. If you continue to turn upwards, the shoelaces will easily slip off. So the position of the circle should not be too close.

04. Finally, pass the remaining shoelaces through the gap at the top. At the beginning, the curved gap just let the tail of the shoelace pass through, thus tying a beautiful spiral knot that is not easy to spread. Isn't it simple?

05. Just tie the shoelaces on the other side in the same way. Finally, adjust the angle of shoelaces to make them look more fashionable. Have you learned how to tie the spiral knot at the end of shoelaces like this?

The method of tying the spiral shoelaces is 3 1. First of all, we should choose the shoelaces to be tied, such as full-hole system method, internal cross system method, cross system method, double X system method and so on. , a wide variety, fashion.

2. Tie the shoelaces according to the shoelaces you choose, and then cross the left shoelaces with the right shoelaces.

3. Fold the remaining shoelaces on one side in half to form shoelaces at both ends, and then fix the shoelaces at both ends of that short piece with your left hand and take out a shoelace.

4. Wrap one shoelace around the two shoelaces fixed by the left hand. After winding, tighten and pull down the shoelaces on the side.

5. Finally, it presents a spiral shape, which is very beautiful and elegant, novel and chic, and more fashionable than ordinary knots. The shoelaces on the other side are tied in this way, and both sides are symmetrical.