Current location - Health Preservation Learning Network - Healthy weight loss - How to wash off the silicone mobile phone case after dyeing?
How to wash off the silicone mobile phone case after dyeing?
When cleaning the silicone mobile phone case, you can try to use detergent, toothpaste, toothbrush, wind oil, cotton swab, eraser, rag and other tools to clean it with water. I suggest that you don't rub it too hard, just put it back in your mobile phone when it is dry. The specific steps are as follows:

Method 1: Small tools to be prepared: detergent, toothpaste, toothbrush, wind oil, cotton swab, eraser and rag;

65438+

2. If there is dirt and dust on the phone case, you can use a small toothbrush to clean it with some toothpaste. If it is greasy, wash it with a toothbrush dipped in detergent.

3. If there are sticky stains such as glue on the mobile phone case, apply a cotton swab to the material evenly with a little wind oil essence, and then clean it with a small toothbrush to remove stubborn stains. ;

4. Finally, everyone is drying the phone case with a dry rag, and then the phone case can be put back on the beloved phone;

Method 2: 1. First, it can be soaked in washing powder and detergent. After half an hour, brush back and forth with a soft brush. Finally, please rinse the foam with clear water and put it in the shade to dry. This operation is aimed at obvious stains, such as dirt, ink, etc.

2. For the silicone shell that is difficult to clean, you can try it with wind oil essence, dip the stain with a cotton pad, gently wipe it clean, and finally rinse it with water and dry it in the shade. Some cracks on the silicone shell that are difficult to clean can be stuck (fixed) with toothpicks, or soaked in water first, and then cleaned with soap;

4, the white silicone shell is really difficult to clean, boldly try to use disinfectant;

5. In addition, the mask paper that usually sticks the mask can also be used to try on the phone case. The worse it gets, the brighter it gets, and it will soon become new. In the process of cleaning and testing, don't use too much force, just be appropriate. Some shapes are very thin and will break when pulled hard.