1. First, we need to determine the location of the hydropower pipeline. Hydropower pipeline is a concealed project. Both integral cabinets and red brick cabinets need the layout of water and electricity pipelines. We need to know the location of water and electricity in the kitchen, accurately mark the specific standards of these areas on the wall, and arrange the direction of water inlet pipe, drainage pipe and various sockets.

2, the cabinet stove needs to make a corner first. When making a corner, it is best to choose a brick that is compatible with the overall personality of the kitchen. Do a good job in the corner. In the future, the bottom of the cabinet will be filled with cement mortar and tiled. When re-paving tiles, reserve the orientation of vertical partition of tiles according to the plan.

3. According to the measured and planned mesa standards, the mesa structure to be poured is made of wooden keel. The steel bar (6- 10mm) is cut to a suitable size and used as the steel bar skeleton of the pouring platform. Suppose it is a place where special load-bearing is needed locally, besides the steel skeleton, it can also be used as domestic reinforcement. After pouring the skeleton, tie, bind and fix it with iron wire or copper wire.

4. After the cabinet structure is completed, it shall be poured with gravel, sand and cement. Usually, after pouring 1 day, water is sprayed for initial curing, and it will dry after 7 days.

5. After the poured cabinet is completely dried, care about the tiles of the columns and cabinets;

6. Paste the cement countertop with cement slurry and repair the countertop with grinding wheel. Assuming that there is a plan for equipment stone countertops in the later stage, the countertops here can be repaired and leveled just to prepare for the equipment bought in the later stage.

7. Stick the waist line of the cement countertop, and you can use tiles or other broken bricks. There is also a popular mosaic effect.

Matters needing attention in expanding data red brick furnace

1. You need to leave a sink standard in the cupboard door before making the cooker, so you need to measure it before customizing it. Once the cement tile is solidified, if it is to be changed in the future, it can only be knocked with a hammer.

2. The sink of the brick cabinet is also a problem that needs attention, and sufficient details need to be left. The edge of the sink is very thin, and there may be several layers of edges. Assuming there is not enough space, it is difficult to equip the sink.