Current location - Health Preservation Learning Network - Health preserving recipes - Senpu health watch is a mechanical watch or an electronic watch, and there is no manual. What should I do if the watch chain becomes longer? please
Senpu health watch is a mechanical watch or an electronic watch, and there is no manual. What should I do if the watch chain becomes longer? please
Steps/methods 1:

1. Turn the handle of the watch detacher. Unscrew it and put the thimble back on the flat edge!

2. Align the small pins between the watchbands to be disassembled, screw on the handle of the watch detacher and eject the small pins.

3. Put the world watch strap into the "slot" of the watch remover (the steel bolt for clamping the needle has two ends, one end is flat, the other end has a slit, and the other end has a clamping position, so the sharp needle should be removed from the table.

One end of a flat head cannot be pushed out from one end of a straight line)

4, according to the size of the wrist adjustment to the appropriate length, and then put your hands back in the opposite direction of the arrow, put the strap.

But pay attention to the strap, you must first make sure that the strap is not made of gongs, but of nails or hairpins. You can go from small mouth to big mouth, which is OK! No matter how difficult it is to remove the strap, it will be done in less than a minute!

Matters needing attention

The thimble of the watch adjuster must be aligned with the pin of the strap, otherwise the watch adjuster will be damaged.

Do not screw the knob of the instrument regulator into it, otherwise the instrument regulator may be scrapped.

Steps/Methods of Using Instrument Regulator 2

1, direction of bracelet. Please read the arrow on the back of the strap carefully before you are ready to disassemble it. Generally, the downward arrow of a watch bracelet indicates that it is big and small. Put the watchband into the groove of the watch adjuster and aim it at Confucius in the direction of the arrow.

2. Take out the watch pin. Loosen the handle of the watch detacher, put the watch band into the watch cylinder, keep the steel needle of the watch detacher aligned with the pinhole of the watch band, and tighten it gently, so that the steel needle connected with the watch band will pop up. If the watch strap is long, it is recommended to remove the same number of knots on both sides of the bracelet to ensure the balance when wearing the watch.

3. Reinstall the watch pin. After disassembling the watchband to the appropriate wrist size, connect the two disconnected watchbands first, and then push the steel needle into the missing part according to the second step or beat it with a hammer! (Note: When reassembling the watchband, it is best to insert the steel needle in the direction opposite to the arrow and select the end of the steel needle to advance, which will make it easier to install).

Matters needing attention

When reassembling the watch pin, first disassemble the watch band to the appropriate wrist size, then connect the broken watch band, and then push the steel needle into the unexposed part according to the second step or knock it with a hammer.