How to inject water without an injector?
Items prepared in advance: (1) Two towels (one under the exhaust port and the other under the water injection port to prevent water from overflowing and wetting the bed). (2) Foot cover (on the bed when entering the door for installation). (3) Water pipes, water pipe clamps, bottle mouth screwdrivers and pliers. Installation and Precautions (1) Take out the bedspread, unzip it and lay it flat on the bed (a layer of bedding should be laid under the bedspread to protect it and keep it warm at the same time). (2) Take out the capsule, put it flat in the bedspread, with the two water inlets facing upwards, and adjust the position. Put the thermostat and the wire street into the capsule (the wire street should pass through the hole of the bedspread and be placed outside the bedspread), and put the probe under the capsule body; Lift and open the water injection port and exhaust port. (3) Insert one end of the water pipe into the water inlet and start water injection (the water pipe head should be firmly inserted to avoid excessive water pressure and the water pipe head rushing out of the water inlet to wet the bed and the ground); At the same time, insert the exhaust pipe into the exhaust hole of the capsule and start to exhaust (check whether it is ventilated). (4) When water is slowly injected into the bed, wipe some water drops from the depths of the water injection port with a towel prepared in advance at any time. (5) During sleeping at home, try to exhaust the gas in the capsule. You can squeeze the whole capsule from the head end to the vent end to exhaust as much gas as possible. When the capsule is almost full, but there is still a lot of gas in it, you can fold the water pipe first and stop filling water. At this time, press the capsule to push out the gas as much as possible, and then continue to fill with water. When the flushing is more than normal, colleagues in the exhaust should try their best to squeeze the soft crystals in the capsule to the flushing side to prevent the soft crystals from gathering. When the problem reaches a certain hardness, turn off the faucet in time, fold up the water pipe head and pull it out, put it into the spare bucket, cover the plugs of the water injection port and the exhaust hole and press it down (pay attention to wipe off the residual water drops on the capsule). (6) Spread another capsule in the bedspread, and pay attention to align the two capsules as much as possible. (7) After the two liners are filled with water, turn on the power supply of the thermostat, check whether the water bed is electrified, and pull up the zipper of the bedspread after confirming that the water bed is heated normally. (8) After installation, please spread a quilt on the soft crystal water mattress and plug it around to achieve the ideal thermal insulation effect.
How long does it take to heat up? Do I need to turn off the power after heating?
The heating pad needs to be heated for 20 minutes. Usually, after buying an electric heating pad, you just need to unpack it, put it where you want to use it, plug in the power supply, turn the switch to high or low temperature, and heat it for a few minutes before you can use it. If the poor quality electric heating pad is used for a long time, it may leak electricity if it is not well maintained, so it is best not to use it when sleeping.