Absolute dry goods grounding gas
Nowadays, many people choose to buy seat covers online, which is cheap and affordable, but the installation has become a big problem. Please find a beauty shop to install it. After all, you didn't buy it from him, and you didn't pay enough attention to the installation. Some people will find fault with you, saying that your seat cover is not well booked, where it can't be installed, and where it doesn't match the post. In fact, as long as the seat cover version is right, 90% of the problems come from installation. Why are there so many problems when I buy and install online?
I have been making seat covers for many years, and I would like to share my little experience here, hoping to help everyone, and also hope to help netizens who seek installation help in many forums!
Okay, cut the crap and get to the point!
The picture was taken when I went to the stall to install seat covers. Please forgive me for not bringing it!
1. First, the front seat, first distinguish the left and right seats. Look at the driver's seat. The side is inward with a mobile phone pocket. Use this to confirm that 100% is accurate. You can also look at the airbag holes, which are all outside.
2.
3. The left and right long straps (rubber straps), tied with iron wires, can easily pass through the rubber shell, and then hook the front seat with the iron hook inside. Below is the schoolbag belt. Many people's seats are loose and wrinkled, but they are not tightened here. When you install it there, you should tighten it many times, and you should pull it there several times after the two sides are adjusted (don't pull the belt hard, it will break, but pull it when you adjust it)
3. 1. The cotton blanket (hook and loop) at the back is always three pieces, with two small pieces in the middle (the third picture in step3). These two small pieces are used for adjustment. If there are wrinkles in front, just pull out two small pieces, which can be solved well.
4. Wrinkles are prone to appear on both sides of the back. At this time, you can effectively solve the problem by touching down and pulling down.
5. Back seat: Many cars just lift the back seat directly and hook it diagonally one by one. Pay attention to the adjustment of the seat surface, and then fasten it below. Many crumpled columns are not fastened under them after installation.
6. This is usually deleted. If his car is made of water pipes (with plastic hoses around it), it can be put on directly, and the water pipes can be stuffed into the gaps.
6. The price of the car seat cover is relatively high, because of its technology, version collection and repeated verification, and the high requirements of many production personnel.
7. Because of the particularity of his handmade seat cover, when the production line girl is nervous and her hand shakes, she may lose one centimeter more. This small problem can be completely solved by correct installation. Please rest assured.
If you buy a seat cover, you can try to install it yourself. That's interesting. There is no need to call the beauty shop and spend that money.