1, flat panel is a measure to save electricity when using refrigerator.
2. Adjust the water funnel and aim at the position of the water tray.
Don't adjust the temperature of the refrigerating room below 0℃, usually 2-6℃, to avoid water freezing.
4. Be careful when freezing drinks. Plastic containers with lids should be placed on food shelves with doors. If you put them on the food shelf, you should tighten the lid to prevent the liquid from flowing out.
5. When using the refrigerator, opening and closing the door is an important task, and care should be taken to prevent cold running; If the sealing strip is found to be damaged, it should be repaired in time; It is also required to pay attention to whether there is dirt on the door edge and tape at any time, and wipe it off immediately if found.
6, hot food is not allowed in the refrigerator, wait until it is naturally cold to room temperature, and then put it in the freezer.
7. For food with more water content, it should be packed in plastic bags, and the mouth of the bag should be tightly tied to prevent the water vapor in the food from evaporating and increase the water accumulation in the refrigerator.
8. The temperature in the freezer should not be lower than 0℃, and should be controlled at 2-6℃. At this time, bottled drinks will not explode.
9. In summer, put some water in the water container outside the refrigerator, then connect a rubber pipe to the outlet pipe in the refrigerator and immerse the other end of the rubber pipe in the water, so as to prevent the hot air outside from entering the refrigerator and dripping.
10, when freezing ice cubes or popsicles, the water in the ice maker should not be too full, and it is generally better to add 80% of the capacity.
Second, the refrigerator freezer water causes
1, the water leakage hole is blocked; If the blockage is found, cut off the power supply and dredge it with thin wire.
2. When food is stored, the temperature is too high, and it is directly put into the refrigerator without cooling. Hot air contains a lot of water, and cooling it in the refrigerator will cause a lot of condensed water. The generation of condensed water is greater than the discharge speed, which will cause water accumulation.
3. Too many times to open the door or the door is not closed tightly, resulting in a lot of hot air entering the refrigerator. Hot air will produce condensed water in the process of condensation, and the production of condensed water is faster than the discharge speed, which will cause water accumulation.