Equipment required:
Tape measure: used for precise positioning of shower screen. Marker: used to mark the position after determining the installation position. Electric drill: it plays the role of drilling screw holes. Screwdriver: used to remove the mounting screws. Hammer: It can be used to hold embedded rubber particles or nails. Glue gun: used to install glue seal after shower curtain is blown.
Check spare parts:
Because the function of shower glass screen is relatively simple, it mainly plays the role of blocking water and distinguishing dry and wet areas, so there are fewer spare parts and the installation method is much simpler than that of shower room. The main spare parts are: a frame, two tempered glasses and several screws. Although the installation of shower screen is simple, it is recommended that children's shoes with no installation experience should be operated by bathroom installation professionals.
Installation steps:
Assemble the shower curtain frame and assemble the frame and glass. When assembling the shower glass screen, the sealing strip with sealing, mildew-proof and mute functions should be installed at the edge of the glass first, and then the aluminum frame strip should be installed. Fix the aluminum bar of the protective glass as a frame, and then connect and fix it on the wall through the frame with a screwdriver. Move the assembled shower screen frame to a position where two people need to install it, and then compare the exact positions. One person will hold the frame steady, and the other person will mark the installation position and screw hole position with a marker pen (pay attention to keeping the glass screen horizontal). Remove the frame, and then use an electric drill to punch holes in the screw holes (be careful to ask the owner if there is a water and electricity layout, and don't pierce the wires or water pipes). Install the embedded rubber particles with a hammer. Then move the frame to the installation position and fix it with screws. At this time, it is necessary to keep the shower screen level. Then install the sliding door of shower screen glass and stick it well. Install the sliding door pulley on the glass, put the pulley into the reserved hole on the glass and put it in the corresponding position, then debug and install the lower pulley with a screwdriver and fix the pulley. Glass sliding door is usually fixed by assembling the upper wheel first, and then assembling the lower wheel to fix the sliding door. Install sealing strips on glass sliding door for sealing and silencing. Install the handle of glass sliding door, and the glass hole at the corresponding position will come out. Just use a screwdriver to fix the handle and screw in a fixed position. Test whether the sliding door is smooth and seamless, and fill the gap seal of the interface with waterproof and mildew-proof sealant after passing the test.
Above, we introduced some interesting knowledge about the installation of glass screen partition. The first part introduces the tools that need to be prepared before installing the glass screen partition. Only when the tools are fully prepared will the later construction be very smooth. Then, we introduced a necessary spare part to check the installation of glass screen partition. In the last part, we introduced the specific steps of glass screen partition installation for your reference.
Tubatu Online provides you with "every decoration quotation, 1-4 local decoration companies, 3 sets of decoration design schemes" and the decoration pit avoidance strategy for free! Click this link:/Zhu Ye /zxbj-cszy.php? to8to _ from = SEO _ zhidao _ m _ jiare & amp； Wb, you can get it for free ~