How to fasten a buckle belt, the most important thing is practical and durable. There is more than one style of belt, and different styles have different fastening methods. The following is a fastening method that I arranged. Come and have a look.

How to tie a buckle belt 1 1. Bow tie method

The ring band can be tied in a bow. First, you should hold the left and right sides of your belt with your right thumb and forefinger. Cross the two ends of the belt respectively, and put the reserved long belt head into the belt from the back position, which needs to be placed in the middle position. Then fold the short band in the back direction. Then the other belt head, like the front of the short belt head, will be wound and a circle will appear at this time. Finally, wrap the long ribbon around the center of the circle, and adjust the length of the ribbon after tightening, so it looks like a very beautiful bow. This kind of lacing is more suitable for wearing pants or shorts.

Second, the cross-system approach

An endless belt can also inherit the cross buckle, which is a very traditional method, simple and easy to master. First, pick up a belt with a hoop, and then you need to use your right hand. Then pick up another belt with your left hand and pass through the middle round mouth, and then gently pull it in. And to adjust to the best length, the belt looks harmonious, that's all. This way of tying is more suitable for wearing skirts.

Third, the back binding method.

A belted belt, if tied at the back, will give people a very elegant feeling. First, pass a part of the belt with iron ring through the circle above the belt, then slowly extend to the back position, and finally extend the other end to the back position together. Tie the two straps together and put them in the hoop. When you put your belt behind your back, you must be careful not to be too tight. You need to loosen it a little, which will look natural. This kind of lacing is more suitable for wearing coats and windbreakers.

Illustration of how to fasten a belt with 2 1 rings with a ring buckle.

1, bow tie method: fasten the belt first, and then tie a knot on the belt.

2, cross-tie method: first buckle, and then tie a beautiful summary on the single ring belt at the tail.

3. Curling method: A single band passes through a small ring, and several rings can be punched on it by using the remaining large single band.

4. Double-classic system method: first lay a single belt, and then lay the single belt at the tail into a small roll.

5. Double-knot method: First, tie all the single belts, then tie the tail next to the buckle and tie two knots.

How to fasten the buckled seat belt 3 The fastening method of the imperforate seat belt is as follows:

First, prepare a non-porous belt, as shown in the figure below.

Second, find out the two loops of the belt and one side of the belt, as shown in the figure below.

Three, one end of the belt through two rings, as shown in the figure below.

Fourth, use the back, bypass the short ring and pass through the back from the long ring, as shown in the figure below.

Five, the force can be stretched, as shown in the figure below.

Sixth, the effect is shown in the figure, so that the non-porous belt is tied well and cannot be easily loosened.