How to install:
1, open the package
We dragged the whole car out of the box and took out all the packages. These inner packages contain parts, so don't throw them away easily.
When the inner package is opened, it can be seen that there are roughly several parts: a sub-frame, a seat cushion, a handlebar, a pair of safety pedals, an instrument, a frame support bar with anti-skid pulleys (rear), a horizontal regulating valve (front), a number of screws and other accessories.
Step 2 repair the base
Push the car across the ground first, and then fix the base below, so that the car can stand up.
To install the base part first, add an adjustable base, which can be set as needed.
3. Install the front bracket
It is also adjustable to install the bracket at the front end of the car in the same way. The horizontal regulating valve is placed in front of the frame and installed on the right side with anti-skid pulley. After determining the height, tighten it.
Step 4 Install handrails
Insert the handrail lifting pipe into the groove, pay attention to the protruding part of the handrail lifting pipe, then tighten the handrail adjusting screw, and then tighten the adjusting screw after adjusting the position of the lifting pipe.
Loosen and unscrew the four screws above the riser counterclockwise with a hexagon wrench; Then put the handrail on the lifting pipe, and then hold the fixed handrail with the four screws that have just been removed. Be careful not to forget the screw washer; Tighten the screws with a hex wrench.
Step 5 Install the seat cushion
(1) First, insert the riser into the groove with the protruding part facing backward, then tighten the adjusting screw of the riser, and then tighten the adjusting screw after adjusting the position of the riser.
(2) Then put the front and rear moving tubes of the rotating bicycle seat into the moving groove (i.e. the protruding part on it) and fix them with the adjusting screws.
(3) Install the seat cushion of the exercise bike. When installing the seat cushion, first loosen the screws at the bottom of the seat cushion, then put the seat cushion into the moving tube, adjust the angle of the seat cushion, and then tighten the screws on both sides of the seat cushion with a small wrench. At this time, special attention should be paid to tightening, otherwise the seat cushion will become unstable and inclined when people sit on it.
6. Install the pedal pedal
Take out the pedal and distinguish the left and right of the pedal. In general English, l stands for left and r stands for right. Install the right pedal of the spinning bike first, make sure that the pedal position of the spinning bike is marked with R, then find the pedal marked with R and install it and tighten it clockwise.
The installation method of the left pedal is the same.
7. Install the instrument
Install the instrument holder. First, unscrew the screws on the musical instrument fixing frame of the spinning bike, then cover the musical instrument on the handrail and fix it with screws. Then install the battery on the exercise bicycle instrument, slide it in the direction of the installation drawing, and then connect two wires. Because these two wires are heart rate sensing wires, there is no distinction between left and right.