2. Hawthorn can be used to paste the bottom of the pot. If the bottom of the pot is burnt, you can put some hawthorn in the pot and add a little cold water to boil it (don't boil it dry), and the bottom of the pot can be removed soon.
3, tomatoes go to the bottom of the pot, a few tomatoes that are not very good are cooked in the pot, and they will naturally fall. 4, beer and white wine to paste the bottom of the pot. When cooking, you accidentally burnt the pot, and there was a hard shell at the bottom of the pot. If it is not easy to brush off, you can pour a little white wine and beer and add a little water (the ratio is 1: 1:0.5), and the lid will be easy to brush off after 5 minutes.
5, apple skin or pear skin to paste the bottom of the pot. Add some water to the apple skin or pear skin, and then it will be cleaned.
6, oranges to paste the bottom of the pot. Cut a few oranges and boil them in a pot. If you keep them stuffy all night, the paste will turn up the next day and it will be easy to remove.
7, waste phone card, magnetic card paste washing pot. It is inevitable to burn the pot when cooking. If you use a hard shovel to clean the coke scale, it will cause scratches. If you use a wooden shovel, it is difficult to completely remove the scorch. Operation method: use the card along the edge of the pot and gradually scrape off the burnt skin. Be careful that scraping doesn't require too much force. If the card is hard plastic, it can also be used to scrape the dirt on the gas stove.
8, add a little vinegar, hot water to burn, you can wash it off.
9. Pour a little rice into the pot and let it ferment naturally. After 2 days, after smelling the sour taste, remove the dust on your hands.
10, let it dry on low heat for a while, sprinkle some salt when smoking, shake it for a minute, then turn off the fire and wipe it again, so that it can be removed cleanly, without leaving any bottom or burning smell.
1 1. You can directly wipe off the black part of the bottom of the pot with cleaning balls and washing powder.
12. Apply toothpaste. Rinse some water with a cloth. Rub it hard. It is economical and does not hurt the pot. But it may take some effort to wipe it.
13. Soak in high-concentration sodium hydroxide aqueous solution (such as 100g water and 50g sodium hydroxide, because of its strong corrosiveness, it is necessary to take acid alkali resistant gloves and cannot be used for cleaning aluminum products), and then scrape it with steel wire balls. If "sodium percarbonate or sodium perborate" is found, you can directly pour boiling water, add boron or carbon, soak it at water temperature and pour it out. The above two methods.