Q: How should the feed mixer be used? What are the common problems in application?
Satisfied answer:
1. Before the feed mixer is used, the motor rotor must be rotated vigorously to repair whether the tooth claw, hammer blade and its motor rotor are flexible and firm, whether the shell collides, and whether the conversion direction of the motor rotor is consistent with the direction indicated by the arrow symbol of the equipment.
2. The "clamping screw" of the production scheduling pinch roll is 0. 1-0.3 mm between the pinch roll and the template. During debugging, take 15kg granular materials, preferably cold-skinned chaff or 5kg peanut meat plus 15kg wheat husk, and carry out water pressure test. Repeated rolling extrusion 15 minutes, the feed in the template hole can not be pressed out, and then extrusion until everything is normal.
3. When using the feed mixer, the workers should bypass the tangent direction of the hammer rotation, and are not allowed to wear gloves to feed, and their hands should not cross the safety line to prevent the use of bronzes and sticks instead of hand feeding.
4. Pay attention to the activities of the feed mixer in time when working, and the feeding must be symmetrical to avoid traffic jams and not work at high load for a long time. In case of vibration, excessive noise temperature of rolling bearing and fuselage, material splashing, etc., stop the machine immediately for repair, and then work again after solving the shortcomings.
5, in order to better safety in production, when the cover is taken out, you must first cut off the switching power supply and turn off the power switch of the equipment, and then touch the pressure plate with your hands and other items. In addition, it is necessary to check the tightness of each component after the machine and equipment are used up. If you see any marks falling off, tighten them immediately and check whether the tightness of the drive belt is appropriate.
6. When using the feed mixer, sometimes there will be abnormal noise. The first way to deal with it correctly is to make the machines and equipment rotate at high speed and listen carefully to where the noise comes from. If there is abnormal sound in the middle of the tanker, adjust the movable screw in the fuel tank. The second is to check whether the blades are thrown backwards and calibrate the motor rotor.
In addition, when using the feed mixer, sometimes the feeding fails or the feeding efficiency becomes slower and slower. At this time, several inspections can be carried out. First, check whether the flour bag on the air outlet is deposited too much for a long time. Second, check whether the picture leaf of Xiaolong in the tanker is seriously damaged. Third, check whether the conveyor belt is loose or loose due to long time. Fourth, check whether the rated power of the motor is normal or not.